Melamic paint work on frames or doors

Melamic paint work on frames or doors.

Does anyone know what is the standard procedure for painting melamic? Well, this time we discuss it together, because our builders often do melamic paint and after that we draw conclusions for the process as below.

Before starting, the first thing that is needed is a compressor with a hose and spray tool. Then the edge wall, or the part you don’t want to install can be covered with newspapers using bag glue. Then the finishing stage can be started as below.

Door frames that are not painted
Door frames that are not painted

Melamic paint work on frames or doors

Kusen Pintu yang beum dicat

Stages of Melamic finishing work:
1. Rub and Blaching wood with H.202
H 202 is a special chemical for bleach if the painted door is a door or frame that has been painted, or repainted. This medicine is specifically for removing stains or removing existing paint. Medication can be found in paint shops.

2. Rub wood with sandpaper to make it flat
To process wood sand, select sandpaper that is for the initial process of tilapia in smoothness 240. Can be purchased at the nearest paint or material store.

Melamic paint work on frames or doors

3. Put the wood filer to cover the pores “wood and sandpaper
For putty you can look for in the nearest paint or material shop, there are several choices, it can be with car putty like san polac, or special wood putty. If the door to be painted is bad, it’s better to use San Polac.

Painting Services Kusen, melamik, duco
Painting Services Kusen, melamik, duco

Melamic paint work on frames or doors
4. Enter the base color according to choice and pure sending layer 2x layer
The next process can be painted basic with two layers, to paint the base is not used as a measure for the paint leveling process, adjusting to the painted frame only.

5. Quality control and rub 240
After finishing the basic painting process, it can be sanded again with sandpaper 240.

Melamic paint work on frames or doors

6. Setting the color to suit what you want
After that it can be adjusted with the selected color, sprayed evenly on the frame according to the alignment. For professionals, this workmanship is easy, but for new ones, we must be more patient with each process.

7. Sending pure 1x layer
Pure layer 1 layer, so the color will get thicker.